Tools/plasma
CUT-50 Plasma cutter
Introduction
The CUT-50 Plasma cutter is a tool that can cut sheet metals using a jet of super-heated plasma in a way similar to a laser-cutter cuts through plastics. Using an electrical supply similar to a welder and a jet of high pressure air supplied by the compressor it melts a thin channel through the metal and sprays the molten metal out the far side of the sheet. Although this tool uses a technology similar to a welder it produces a much smaller heated zone and far less UV light so while it is still a tool that requires skill and knowledge to use safely, induction is recommended but not required. It's normally in the metalworking desk in drawer B3B, the spares for it are in the shelves above the desk in the north-west corner of the workshop. The CUT-50 Plasma cutter is a 50A plasma metal cutting system that can cut steel up to 8mm thick. It can cut aluminium, brass, and stainless steel as well but additional safety equipment is needed.
Current Status
| Date | Status | Comment |
|---|---|---|
| 18th February 2019 | Fully Functional | Input filter board has been repaired and is now operating normally |
Planned Upgrades
Parts and upgrades that are planned/Budgeted/Purchased for in the near future
- None planned
Plasma Cutter Caretakers
Inductions
Usage requires use of Air compressor.
The following people are able to provide inductions on the Plasma Cutter
| Name/Contact | Notes |
|---|---|
| Steve-R |
Maintainers
These are the people who look after and repair the plasma cutter, they're the ones to contact if there's any problems with it
| Name | Notes |
|---|---|
| Steve-R | In reading around 50% of the time, fast response if in reading |
Recent Changes
If you make any non-trivial changes to plasma cutter or perform maintenance please note it here, delete records older than 1 yr