Anonymous user
Tools/laser: Difference between revisions
→Recent Changes
imported>Ruperte (→Recent Changes: Fixed HT Relay miss-wiring) |
imported>Ruperte |
||
Line 168:
If you make any non-trivial changes to the Pirahna 1060 or perform maintenance please note it here, delete records older than 1 yr
* Realigned due to poor cutting. Mirror 2 angled too far left, so almost completely missing the housing. Also the actual main laser tube is now slightly too high. Didn't change as this will require a full moving out of the entire machine, so I've averaged out the error as best I can for now, but will need doing soon. [[User:Ruperte|Ruperte]] ([[User talk:Ruperte|talk]]) 23:20, 4 July 2021 (BST)
* HT PSU enable relay reported not to be powering off, after first switch on. Found wiring error with the new transient suppressors. It turns out the supplied diagram for the replacement relay was wrong, so the suppressor was accidentally wired between common and coil. This has been corrected and is now wired between Common and Normally Open. It should be noted that even after the switch 3 is turned off, the relay disconnected right away, but the HT PSU takes about 10 seconds to fully drain it's caps, so the laser can be weakly fired during that time period. [[User:Ruperte|Ruperte]] ([[User talk:Ruperte|talk]]) 15:20, 24 June 2021 (BST)
* Lens replaced, some signs of dust in the air system, possibly polypropylene makes dust fine enough to pass filter? [[User:Stever|Stever]] ([[User talk:Stever|talk]]) 21:56, 16 June 2021 (BST)
| |||