Anonymous user
Tools/laser: Difference between revisions
Troubleshooting table
imported>Ruperte (How to fix if RDWorks has lost it's settings) |
imported>Stever (Troubleshooting table) |
||
Line 17:
|}
== Laser Troubleshooting ==
Here's some common issues that crop up on the laser and how to fix them
{| class="wikitable"
|-
! Symptom !! Cause !! Fix
|-
| RDWorks is coming up in hieroglyphics || Usually means it has managed to crash, and had defaulted back to it's out of the box setup - which is Chinese! || To reset it, go to the Help Menu - then to the Language and pick English.
|-
|rowspan="2"| RDWorks isn't talking to the laser || RDWorks has crashed and defaulted back to it's out of the box setup || At the bottom right, press the what looks like a button, where it says "USB: Auto"
|-
| RDWorks version 8 or later has been installed || The laser will not work with any version of RDWorks after version 7, make sure you're running the right one
|-
| Bed won't rise high enough || The head has been knocked and moved upwards, preventing it from focusing properly on thin sheets || To fix it home the laser both in the XY and the Z modes, place the 6mm focus block under the head while at the home position, and then turn the knurled ring on the red tube to release the head, make sure to be holding it so it doesn't drop out!
Set the head height so that it's just touching the focus block while in that position and tighten up the knurled ring again, you'll now have the head in the proper focus position and can cut using normal procedure.
|}
▲At the bottom right, press the what looks like a button, where it says "USB: Auto". Then change it to "web", and a ip address of 172.16.0.100
== Old wiki content ==
Line 52 ⟶ 61:
Thickness 10 /15mm?
Software:
|