Project/ElectricalWorks/MainRoomRefit

Introduction

A project to cover the electrical works in the Main Room refit.

Clear the west wall, install a plywood skin, then install four work stations with power and data.

Objectives :

• Replace the existing West Wall mounted sockets with sockets in dado trunking on the new wall.
• Move the circuit feed onto the kitchen distribution board
• Maintain power for the heat pump
• Integrate power and controls for the extractor fan
• Provide capacity for the 3d-printer stand at a future date
• Install new data wiring

Current State

The existing sockets are connected to a 32A ring main, wired back to the Main Board.

The extractor fan is connected via a switch-fused connection unit, which then feeds a separate speed controller and out to the fan itself. Verified that this is fused at 5A, and the fan is fed by a 5 core 0.75mm flex from the controller.

A 20A circuit from DB2 connects to an isolator for the heat pump.

Planned Work

• Test the circuit is not feeding the Server Rack in the cupboard.
• Identify cable route from ceiling into back of new plywood wall
• Arrange temporary power for the Design PC's and 3d printers. Need 8 sockets. 2 x 4-gang leads from Electronics benches ?
• Disconnect the existing sockets and data cabling, and remove back to the Main Board.
• Disconnect and remove the extractor fan wiring. Install extra cable to the fan to allow for fitting behind the plywood wall and into the dado trunking
• Pull through new 4mm T&E cable between the Kitchen Board and the Main Room for the new ring circuit.
• Pull through 8 x data cables for new network sockets in dado trunking.
• Install new dado trunking, and fit sockets and data points.

Photos and Drawings

• 

  Main board

• 

  Board DB2A

• 

  Kitchen Board

• 

  The main room west wall

• 

  The Heat pump

• 

  Fan controller

• 

  Fan controller wiring

• 

  Fan controller wiring

Materials

• Schneider CA3W dado trunking - 3m length, x 3
• Schneider CAI3W inside angle, x 2
• Schneider CAX3W outside angle, x 2
• Schneider CLB32W 25mm double gang box, x 14
• Schneider CLB31W 25mm single gang box, x 6
• Schneider CLB51W 50mm single gang box. Option for deeper accessories
• Schneider CLB52W 50mm double gang box. Option for deeper accessories
• MK Logic Plus double gang sockets, x 14
• Double outlet Cat6 data points, x 4
• 4mm T&E cable
• 2.5mm conduit cable
• Cat6 data cable and RJ45 plugs
• Metal plasterboard fixings and P-Clips

Progress

• First fix materials bought or confirmed already on site.
• Examined the extractor fan control unit to determine the cabling out to the fan itself.
• Installed 2 x surface pattress boxes in kitchen ceiling for the 3D printer spur and the kitchen display spur.
• Examined the boxwork around the roof beam against the west wall.
  • Confirmed this is plasterboard and has enough room for a cable access route.
  • Will require fire-retardant foam to seal the cable access holes after fitting is complete.
• Design PC's network re-connected via temporary cable to North Wall trunking.
• 3 x 4-way extension leads prepared for temporary power to the PC's during the works.
• Single trailing socket prepared for the ceiling-mounted projector.