73
edits
imported>Stever (Further moving into proper format) |
m (1 revision imported) |
||
(6 intermediate revisions by 2 users not shown) | |||
Line 1:
{{inductioninfo}}
Induction for the [[Tools/plasma|CUT-50 Plasma Cutter]]
Line 35 ⟶ 37:
| Electrical Safety ||
* Avoiding wet areas (but mention industrial water-damped cutting)
* The plasma cutter plugs into one of the 16A sockets on the pillars. If you need an extension lead use only the high-current industrial ones from drawer B1B of the metal table
* Main terminal on power supply is live all the time at 100V, ensure the guard is in place at all times
* NO RINGS, NO WATCHES!!
* If something does go wrong, shut off power before anything else
|| Let's not get anyone electrocuted
|-
| Metal fume/dust hazards ||
* General hazards of fine dusts, tendency to respiratory issues and headaches, need for for dust masks
* Hazards of
* Why are we restricted to carbon steels? (Cr2O3, Al2O3, NiO, CuO etc.)
** Is there interest in cutting other materials? (Will
|| Metal dust and fume are long term health risks
|-
Line 51 ⟶ 55:
* Inspecting compressor and cut-50
** Looking for any defects or damage
** Are the shields and
** Checking compressor oil level
** Venting the compressor
Line 57 ⟶ 61:
** Testing the compressor safety valve
** Are the hoses and cables in good condition?
* Fitting the consumables, how to examine, check, what constitutes too much wear, show examples of excessive wear if we have any available. Consumables need changing quite often on these cheaper plasma cutters
* Connecting up the equipment, noting that the air source needs to be reasonable clean and water-free, what will happen if it isn't
* Torch safety, electrical hazards, air injection issues, firing out of grit and possibly parts of the head if damaged, must never be pointed at people
Line 63 ⟶ 67:
|-
| Proper settings for the job ||
* Selecting proper pressure and how to cascade the regulators to give smooth regulation.
** Pressures range from around 3 bar for thinner material up to around 8 bar for thicker material
* How to choose a suitable current for your job
** Theoretically you should use 10A + 5A per mm of material thickness for steels, more for aluminium or copper
** But this cutter's gauge reads "Chinese amps" so use about double that
** But the breaker will trip if you select over about 42A so that's your upper limit
|| Getting the settings right for a smooth cut
|-
| Cutting ||▼
* Preparing material using angle grinder/wire wheel
** Consider contaminants
** Getting good ground contact
** Using guides, both metal and wood, possibility of laser cut guides
** Clamping work consider what’s underneath and on the underside
|| The main procedure for actually cutting into things.
|-
** Show a good cut, too much current, too little current, too little air
** Piercing through thin sheets
|| So you can recognise issues when they happen
|-
* Piercing thicker sheet at an angle
* Descaling use
* Maximum thicknesses that can be cut
|| Cutting thicker materials at lower speeds
|-
|| Miscellaneous other topics
|}
▲Cutting
▲ Torch perpendicular and slow even movement
▲ OK to brace on the material
▲ How to recognise problems
▲ Demo on thin sheet
▲ Practice on thin sheet
▲ Cutting on thicker materials
▲ Cutting speed/spark angle (15-20 deg)
▲ Flick-finishing
▲ Demo & Practice
▲ Other topics
▲ Piercing into enclosed spaces
[[Category:inductions]]
|