Tools/metallathe/induction: Difference between revisions

 

{{inductioninfo}}

== Level-1 induction ==

This is the most basic induction and provides only the absolute essentials. With the new card-based access control system coming soon then we may have a lot of people who suddenly need induction despite being already familiar with lathe work. That means this induction needs to be short enough we can do it quickly and in bulk cause we don't want people getting pissed off and skipping it or trying to bypass the control system. This plan for induction is fairly stable now and all trainers should be working from this plan, suggestions for improvements are still welcomed though!

 

== Level 2 Induction ==

This one is to cover people who intend to seriously use the lathe in an upcoming project but who don't need to handle complex or detailed work so quite a bit of what was previously level-1 induction will now appear here. Level-2 induction requires people have completed level-1 induction first and and is broken into 2 modules of 2 hours each.

=== Module 2A ===

{| class="wikitable"

|}

 

=== Module 2B ===

{| class="wikitable"

|}

 

== Level 3 Induction ==

Requires Level 2 induction to be completed first as there's a lot of material to cover on this one so don't want to be going over basics again. People don't have to do the entire level 3 course, and in fact we don't recommend it as covering all of this would take several days and your brain would be about ready to melt by the end of it! Individual topics can be done as needed, the content of this course isn't finalized yet so we're not ready to run it as a full course but if you're specifically interested in one topic then contact a induction provides who offers level 3 to plan out and arrange a short session on that topic.

* turning between centres (Need lathe-dogs to demonstrate the catchplate)

 

== Level 4 induction ==

We welcome suggestions for what should be covered in an advanced course if we're able to run one