Tools/metallathe/DRO: Difference between revisions
Content added Content deleted
imported>Stever No edit summary |
imported>MikeC |
||
Line 8: | Line 8: | ||
[[File:xbutton.JPG|thumb|250px|Selecting the X axis]] |
[[File:xbutton.JPG|thumb|250px|Selecting the X axis]] |
||
[[File:entbutton.JPG|thumb|250px|Confirming a value]] |
[[File:entbutton.JPG|thumb|250px|Confirming a value]] |
||
Turning a diameter turn just enough to clean up a diameter so as to have a completely round diameter with no low-spots ( |
Turning a diameter turn just enough to clean up a diameter so as to have a completely round diameter with no low-spots (due to any irregularity in the stock material). Once a section has been successfully "cleaned up", bring the tool away on the Y axis only (without changing the cross-slide setting) and measure the diameter with a Micrometre or Vernier Calliper. |
||
When you have established the diameter press the X button (shown right), enter the value and press the ‘ENT’ key to store the value. From now on the DRO will automatically convert radial movement to display |
When you have established the diameter press the X button (shown right), enter the value and press the ‘ENT’ key to store the value. From now on the DRO will automatically convert radial movement to display anew the diameter on successive cuts. It is advisable to leave a small amount extra on the diameter and re-measure before going for your finishing cut and final diameter for the sake of accuracy. |
||
<br clear=all> |
<br clear=all> |
||
=== Setting and using the length scale === |
=== Setting and using the length scale === |
||
[[File:zeroingy.JPG|thumb|250px|Zeroing the Y axis]] |
[[File:zeroingy.JPG|thumb|250px|Zeroing the Y axis]] |