Tools/laser: Difference between revisions

Line 57:

Set the head height so that it's just touching the focus block while in that position and tighten up the knurled ring again, you'll now have the head in the proper focus position and can cut using normal procedure.

|-

| Not Enough Extend Space error on the laser panel || You have the workpiece too close to one of the limits of the laser and the head does not have enough space to move around and complete the job. || Move your workpiece a few millimeters away from the edge of the machine and re-run the job.

| "Not Enough Extend Space" error on the laser panel || You have the workpiece too close to one of the limits of the laser and the head does not have enough space to move around and complete the job. || Move your workpiece a few millimeters away from the edge of the machine and re-run the job.

|-

| "Frame Slop" error displayed ||

The job is asking the machine to move outside it's bed area because:

The Origin position is not set right

The Origin mode is not set to "current position"

The job is too large for the machine

||

Check the origin is set where you expect (usually top right)

Set the origin mode (next to origin position) to "Current Position"

Maximum job size is 999mm x 599mm or a bit less for job involving etching

|-

| "Water Error" is displayed ||

No access card in card reader

Lid not closed

Water chiller not running

Low water level

||

Put your card in the reader, if you're inducted then access will be granted

Close the lid.....

Turn on the chiller.....

Ask on the mailing list for help

|}