Tools/laser: Difference between revisions
Content added Content deleted
imported>Stever |
imported>Jmf |
||
| Line 54: | Line 54: | ||
Set the head height so that it's just touching the focus block while in that position and tighten up the knurled ring again, you'll now have the head in the proper focus position and can cut using normal procedure. |
Set the head height so that it's just touching the focus block while in that position and tighten up the knurled ring again, you'll now have the head in the proper focus position and can cut using normal procedure. |
||
|- |
|||
| Not Enough Extend Space error on the laser panel || You have the workpiece too close to one of the limits of the laser and the head does not have enough space to move around and complete the job. || Move your workpiece a few millimeters away from the edge of the machine and re-run the job. |
|||
|} |
|} |
||
== Planned Upgrades == |
== Planned Upgrades == |
||