Tools/bandsaw/induction: Difference between revisions
Content added Content deleted
imported>Stever |
imported>Stever |
||
| Line 93: | Line 93: | ||
| Operation || |
| Operation || |
||
* Check if the welder is in use, they share a power connection and will trip out if both are used at once |
* Check if the welder is in use, they share a power connection and will trip out if both are used at once |
||
* When making the cut, hold the work piece securely against the table, and guide work into the blade. |
* When making the cut, hold the work piece securely against the table, and guide work into the blade. If you can't get the work securely held flat against the table, you can't cut it. Loose work not firmly against the table with snatch and break the blade. |
||
* If you're rip-cutting then you should be resting the work against the fence, if you're cross-cutting use the mitre guide or the vice, if you're cutting curves then you'll have to do it free-hand |
* If you're rip-cutting then you should be resting the work against the fence, if you're cross-cutting use the mitre guide or the vice, if you're cutting curves then you'll have to do it free-hand |
||
* Do not push too hard into the blade, as you will damage the blade and get a poor quality cut. |
* Do not push too hard into the blade, as you will damage the blade and get a poor quality cut. |
||