Anonymous user
Tools/TIG/induction: Difference between revisions
can't slow down too much
imported>Stever |
imported>Stever (can't slow down too much) |
||
Line 189:
* Parameters set using the middle section. We're using DC (Electrode negative), no pulse, HF-TIG in 2T mode. Back and Forward controls step through the parameters that are relevant to the selected mode
** Using the chart on top of the welder to pick settings
** Do not attempt to reduce settings very much to make things easier. Small current reductions may sometimes be needed but if you try to slow down too much the weld will turn to shit and heat affected zone will be huge because you'll be going so slow. You just have to learn to keep up with proper settings.
** If the chart isn't helping then use the following guidelines. Use all the %age changes that apply to your work, e.g. if you're doing an outside corner on stainless steel then apply both -%10 current for Stainless and -10% current for outside corner for a total of -20% change to current and +45% gas
{| class="wikitable"
| |||