Revision as of 15:12, 14 April 2020 (edit) imported>Stever (→‎Suitable Materials for Laser use) ← Older edit		Revision as of 12:28, 15 April 2020 (edit) (undo) imported>Stever (→‎Suitable Materials for Laser use) Newer edit →
Line 30: \| Polystyrene \|\| Yes \|\| Yes \|\| 8mm \|\| Cuts OK but does tend to leave sticky residue on the bed that will require extensive cleaning \|- \| Polypropylene \|\| Yes(ish) \|\| Yes \|\| Unknown \|\| ~~Thin~~Not ~~sheets~~recommended, ~~have~~very ~~been~~prone ~~tested~~to ~~and~~heat-distortion ~~cut~~during OKcutting. Leaves a very sticky and hard to clean residue around the cut and on the nozzle \|- \| Polycarbonate \|\| No \|\| No \|\| N/A \|\| Polycarbonate is not allowed in the laser owing to terrible cuts and high fire risk

Tools/laser: Difference between revisions

Tools/laser (edit)