rLab

Project/ElectricalWorks/MainRoomRefit: Difference between revisions

Page Discussion

Project/ElectricalWorks/MainRoomRefit (edit)

Revision as of 15:10, 24 September 2021

1 byte added ,  2 years ago
no edit summary
imported>Jmf
(Created page with "== Introduction == A project to cover the electrical works in the Main Room refit. Clear the east wall, install a plywood skin, then install four work stations with power and...")
 
imported>Stever
No edit summary
Line 2:
A project to cover the electrical works in the Main Room refit.
 
Clear the eastwest wall, install a plywood skin, then install four work stations with power and data.
 
Objectives :
* Replace the existing EastWest Wall mounted sockets with sockets in dado trunking on the new wall.
* Move the circuit feed onto the kitched distribution board
* Maintain power for the heat pump
Line 16:
The existing sockets are connected to a 32A ring main, wired back to the Main Board.
 
The extractor fan is connected via a switch-fused connection unit, which then feeds a seperateseparate speed controller and out to the fan itself.
 
A 20A circuit from DB2 connects to an isolator for the heat pump.
Line 23:
* Test the circuit is not feeding the Server Rack in the cupboard.
* Identify cable route from ceiling into back of new plywood wall
* Arrange temporaytemporary power for the Design PC's and 3d printers. Need 8 sockets. 2 x 4-gang leads from Electronics benches ?
* Disconnect the existing sockets and data cabling, and remove back to the Main Board.
* Disconnect and remove the extractor fan wiring. Install extra cable to the fan to allow for fitting behind the plywood wall and into the dado trunking
Anonymous user
Retrieved from "https://wiki.rlab.org.uk/wiki/Special:MobileDiff/4660"